SmartPro 120V 1kVA 650W Line-Interactive Sine Wave UPS, Tower, USB, DB9, 8 Outlets
Specifications
Additional Information
- UPC: 0037332189196
- Manufacturer: TRIPPLITE
- Specifications
- Output Volt Amp Capacity (VA): 1000
- Output kVA Capacity (kVA): 1
- Output Watt Capacity (Watts): 650
- Nominal Output Voltage(s) Supported: 100V; 110V; 120V
- Nominal Voltage Details: 120V default (voltage selection via back panel switches)
- Frequency Compatibility: 50 / 60 Hz
- Frequency Compatibility Details: Automatic frequency selection
- Output Voltage Regulation (Line Mode): -13%, + 15%
- Output Voltage Regulation (Battery Mode): +/- 5%
- Output Receptacles: (8) 5-15R
- UPS Output Receptacles (Surge Suppression Only): 6 UPS outlets, 2 surge-only outlets
- Output AC Waveform (AC Mode): Sine wave
- Output AC Waveform (Battery Mode): Pure Sine wave
- Rated input current (Maximum Load): 6.1A (120V), 6.6A (110V), 7.2A (100V)
- Nominal Input Voltage(s) Supported: 100V AC; 110V AC; 120V AC
- UPS Input Connection Type: 5-15P
- UPS Input Cord Length (ft.): 6
- Recommended Electrical Service: 15A 120V
- Input Phase: Single-Phase
- Full Load Runtime (min.): 5.0 min. (650w)
- Half Load Runtime (min.): 14.4 min. (325w)
- DC System Voltage (VDC): 24
- Battery Recharge Rate (Included Batteries): Less than 3.9 hours from 10% to 90% (typical, full load discharge)
- Internal UPS Replacement Battery Cartridge: RBC24-SLT
- Battery Access: Battery access door
- Battery Replacement Description: Hot-swappable, user replaceable batteries
- Expandable Runtime: No
- Voltage Regulation Description: Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 95 to 145 (120v), 87 to 133 (110v), 83 to 121 (100v)
- Overvoltage Correction: Voltage reduction of 12% applies when input is 127 to 145 (120v), 116 to 133 (110v), 111 to 121 (100v)
- Undervoltage Correction: Voltage boost of 14% applies when input is 95 to 108 (120v), 87 to 99 (110v), 83 to 90 (100v)
- Switches: 2 Switches control off/on power status and alarm-cancel/self-test operation; rear panel protected switches support nominal voltage selection
- Alarm Cancel Operation: Power-fail alarm can be silenced using alarm-cancel switch
- Audible Alarm: Audible alarm indicates power failure and overload conditions
- LED Indicators: Status LEDs indicate line power, battery power, AVR, overload and replace battery status - with a 3-LED level meter for load and battery charge level
- Site Wiring Fault Indication: Rear panel site wiring fault LED
- UPS AC Suppression Joule Rating: 570
- UPS AC Suppression Response Time: Instantaneous
- UPS Dataline Suppression: 1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet
- EMI / RFI AC Noise Suppression: Yes
- Primary Form Factor: Tower
- UPS Power Module Dimensions (hwd, in.): 10.2 x 6.8 x 13.2
- UPS Power Module Weight (lbs.): 36
- UPS Power Module Weight (kg): 16.33
- UPS Shipping Dimensions (hwd / in.): 14 x 9.8 x 18.5
- Shipping Weight (lbs.): 39.6
- Cooling Method: Fan
- UPS Housing Material: Steel
- Primary UPS Height (mm): 259
- Primary UPS Width (mm): 173
- Primary UPS Depth (mm): 335
- Shipping Height (mm): 356
- Shipping Width (mm): 249
- Shipping Depth (mm): 470
- Operating Temperature Range: +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius.
- Storage Temperature Range: +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius.
- Relative Humidity: 5 to 95%, non-condensing
- AC Mode BTU / Hr. (Full Load): 107
- Battery Mode BTU / Hr. (Full Load): 455
- AC Mode Efficiency Rating (100% Load): 95%
- Communications Interface: DB9 Serial; USB (HID enabled)
- Network Monitoring Port Description: Supports detailed monitoring of UPS and site power conditions
- PowerAlert Software: For local monitoring via the UPSs built-in communication ports, download PowerAlert Local software at http://www.tripplite.com/poweralert
- Communications Cable: USB cabling included
- WatchDog Compatibility: Supports Watchdog application, OS and hard-reboot restart options for remote applications.
- Network UPS Tools Compatibility: NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at http://www.networkupstools.org/stable-hcl.html?manufacturer=Tripp Lite
- Transfer Time: 4 milliseconds
- Low Voltage Transfer to Battery Power (Setpoint): 95V (120V), 87V (110V), 83V (100V)
- High Voltage Transfer to Battery Power (Setpoint): 145V (120V), 133V (110V), 121V (100V)
- Cold Start (Startup in Battery Mode During a Power Failure): Cold-start operation supported
- High Availability UPS Features: Hot swappable batteries
- UPS Certifications: Meets FCC Part 15 Category B (EMI); ROHS (Restriction of Hazardous Substances); Tested to CSA (Canada); Tested to NOM (Mexico); Tested to UL1778 (USA)
- Product Warranty Period (Worldwide): 2-year warranty, 3 year with registration. Note: Registration is required for 3-year warranty.
- Connected Equipment Insurance (U.S., Canada & Puerto Rico): $250,000 Ultimate Lifetime Insurance
- Downloads: ""
- Manufacturer Product URL: https://www.tripplite.com/smartpro-120v-1kva-650w-line-interactive-sine-wave-ups-tower-usb-db9-8-outlets~SMC1000T/
- Packaging
- Certifications
- Details: "Overview\nThe SMC1000T SmartPro 120V 1kVA 650W Line-Interactive Sine Wave UPS provides battery backup and AC power protection against blackouts, brownouts, power surges and line noise that can damage electronics or destroy data. Ideal for backing up high-performance workstations, servers and network equipment, the SMC1000T switches to battery mode in milliseconds to keep your connected equipment running long enough to save files and shut down safely with no data loss. Pure sine wave output is compatible with active power factor correction (PFC) power supplies.\n\nFeaturing eight NEMA 5-15R outlets and a six-foot power cord with NEMA 5-15P input, the SMC1000T has an internal battery that provides 14.4 minutes of support at half load and five minutes at full load. Two of the eight outlets provide surge protection only for printers and other non-essential devices. Front-panel LEDs indicate load level, power, voltage correction, site wiring fault and battery statuses.\n\nAutomatic voltage regulation (AVR) maintains selectable 100V, 110V or 120V nominal output over an input range of 83V121V (100V), 87V133V (110V) or 95V145V (120V) without using battery power. EMI\/RFI noise filtering improves your equipments performance and prevents damage. A 570-joule surge suppression rating protects your equipment from harmful power surges. With Tripp Lites free downloadable PowerAlert software, the SMC1000T enables safe unattended system shutdown and file saves in case of a prolonged power failure."
- List price: No
Loading...